Specifications - Sony CMT-EP707 Operating Instructions (CMTEP707) Operating Instructions Manual

Precautions (continued)
Before placing a cassette in the tape
deck
Take up any slack in the tape. Otherwise the tape may
get entangled in the parts of the tape deck and become
damaged.
When using a tape longer than 90
minutes
The tape is very elastic. Do not change the tape
operations such as play, stop, and fast-winding (etc.)
frequently. The tape may get entangled in the tape
deck.
Cleaning the tape heads
Clean the tape heads after every 10 hours of use.
Make sure to clean the tape heads before you start an
important recording or after playing an old tape. Use
separately sold dry-type or wet-type cleaning cassette.
For details, refer to the instructions of the cleaning
cassette.
Demagnetizing the tape heads
Demagnetize the tape heads and the metal parts that
have contact with the tape every 20 to 30 hours of use
with a separately sold demagnetizing cassette. For
details, refer to the instructions of the demagnetizing
cassette.
GB
22

Specifications

AUDIO POWER SPECIFICATIONS:
(U.S.A. model only)
POWER OUTPUT AND TOTAL
HARMONIC DISTORTION:
with 4 loads both channels driven, from 120
- 10,000 Hz; rates 15 W per channel minimum
RMS power, with no more than 10% total
harmonic distortion from 250 mW to rated
output.
Amplifier section
Canadian model:
Continuous RMS power output (reference)
European model:
DIN power output (rated) 12 + 12 W
Continuous RMS power output (reference)
Music power output (reference)
Other model:
The following measured at AC 230 V or AC 120 V,
50/60 Hz
DIN power output (rated) 12 + 12 W
Continuous RMS power output (reference)
Inputs
MD IN (phono jacks):
Outputs
PHONES:
(stereo mini jack)
SPEAKER:
15 + 15 W
(4 at 1 kHz, 10% THD)
(4 at 1 kHz, DIN)
15 + 15 W
(4 at 1 kHz, 10% THD)
38 + 38 W
(4 at 1 kHz, DIN)
15 + 15 W
(4 at 1 kHz, 10% THD)
voltage 450 mV,
impedance 47 kilohms
Accepts headphones of
8 or more
Accepts impedance of 8 to
16