Preparing The Remote; Replacing The Battery In The Remote - Sony CMT-C7NT Operating Instructions Manual

3 Connect the power cord to a wall outlet.
If the plug does not fit the wall socket,
attach the supplied plug adaptor (only for
models equipped with an adaptor).
To turn on the system, press @/1.

Preparing the remote

Pull out the insulating sheet to allow
power to flow from the battery.
The remote already contains a battery.
Replacing the battery in
the remote
1
Slide out and remove the battery case.
2
Insert a new lithium battery CR2025
with the + side facing up.
a lithium battery CR2025
3
Slide the battery case back in.
CAUTION
Danger of explosion if battery is incorrectly
replaced.
Replace only with the same or equivalent type
recommended by the manufacturer. Discard
used batteries according to the manufacturer's
instructions.
Battery life
You can expect the remote to operate for about
6 months (using a Sony CR2025 lithium
battery) before the battery runs down. When
the battery no longer operates the remote,
replace the battery with a new one.
To avoid battery leakage
If you are not going to use the remote for a
long time, remove the battery to avoid damage
caused by corrosion from battery leakage.
Notes on lithium battery
• Keep the lithium battery out of the reach of
children.
Should the battery be swallowed,
immediately consult a doctor.
• Wipe the battery with a dry cloth to assure a
good contact.
• Be sure to observe the correct polarity when
installing the battery.
• Do not hold the battery with metallic
tweezers, otherwise a short-circuit may
occur.
WARNING
Battery may explode if you mistreated.
Do not recharge, disassemble or dispose of
in fire.
7