Sony STR-DA3200ES Operating Instructions Manual page 46

Confirming/saving the
measurement results
1
Confirm the measurement
result.
When the measurement ends, a beep
sounds and the measurement result
appears on the display.
Measurement
result
When the
measurement
process
completes
properly
When the
measurement
process fails
2
Press V/v repeatedly to select
the item, then press
Item
RETRY
SAVE EXIT
WRN CHECK
PHASE INFO
46
GB
Display Explanation
COMPLETE Proceed to step
2.
ERROR See "When
CODE XX error codes
appear" (page
46).
.
Explanation
Re-performs the auto
calibration.
Saves the measurement
results and exits the setting
process.
Displays a warning
concerning the
measurement results. See
"When you select "WRN
CHECK"" (page 47).
Displays the phase of each
speaker (in phase/out of
phase). See "When you
select "PHASE INFO""
(page 47).
Item
DIST.INFO
LEVEL INFO
EXIT
3
Press V/v repeatedly to select a
preset number to be used, then
press .
4
Press .
The measurement results are saved.
Tip
The size of a speaker (LARGE/SMALL) is
determined by the low characteristics. The
measurement results may vary, depending on the
position of the optimizer microphone and speakers,
and the shape of the room. It is recommended that
you follow the measurement results. However, you
can change those settings in the Speaker Settings
menu (page 68). Save the measurement results first,
then try to change the settings if you want.
When error codes appear
Try the remedies and re-perform the auto
calibration.
Error code Cause and remedies
CODE 31 SPEAKERS (OFF/A/B/A+B) is
set to OFF. Set it to others and re-
perform the auto calibration.
CODE 32 None of the speakers were
detected. Make sure that the
optimizer microphone is
connected properly and re-
perform the auto calibration.
If the optimizer microphone is
connected properly but the error
code appears, the optimizer
microphone cable may be
damaged or improperly
connected.
CODE 33 (F) None of the front speakers are
connected or only one front
speaker is connected.
The optimizer microphone is not
connected.
Explanation
Displays the measurement
result for speaker distance.
Displays the measurement
result for speaker level.
Exits the setting process
without saving the
measurement results.