7: Calibrating The Appropriate Settings Automatically (Auto Calibration) - Sony STR-DA3200ES Operating Instructions Manual

7: Calibrating the
appropriate settings
automatically
CALIBRATION)
The DCAC (Digital Cinema Auto Calibration)
function allows you to perform automatic
calibration, such as checking the connection
between each speaker and the receiver,
adjusting the speaker level, and measuring the
distance of each speaker from your listening
position automatically. Refer also to the "Quick
Setup Guide" supplied with the receiver.
Before you perform the auto
calibration
Before you perform the auto calibration, set up
and connect the speakers (page 18, 19).
• The AUTO CAL MIC jack is used for the
supplied optimizer microphone only. Do not
connect other microphones to this jack.
Doing so may damage the receiver and the
microphone.
• During the calibration, the sound that comes
out of the speakers is very loud. Pay
attention to the presence of children or to the
effect on your neighborhood.
• Perform the auto calibration in a quiet
environment to avoid the effect of noise and
get a more accurate measurement.
• If there are any obstacles in the path between
the optimizer microphone and the speakers,
the calibration cannot be performed
correctly. Remove any obstacles from the
measurement area to avoid measurement
error.
• When you use a bi-amplifier connection, set
"SUR BAK SP" to "BI-AMP" in the
Speaker Settings menu before you perform
auto calibration (page 69).
(AUTO
Notes
• The auto calibration function does not work in the
following cases.
– MULTI IN is selected.
– The ANALOG DIRECT function is being used.
– Headphones are connected.
• Cancel if MUTING is set to on.
1
Connect the supplied optimizer
microphone to the AUTO CAL
MIC jack on the front panel.
2
Set up the optimizer
microphone.
Place the optimizer microphone at your
listening position. Use a stool or tripod so
that the optimizer microphone remains at
the same height as your ears.
On setting up the active sub
woofer
• When a sub woofer is connected, turn on the
sub woofer and turn up the volume
beforehand.
• If you connect a sub woofer with a crossover
frequency function, set the value to the
maximum.
• If you connect a sub woofer with an auto
standby function, set this function to off
(deactivated).
Optimizer microphone
continued
43 GB