Error Messages - Sony STR-DA2000ES Operating Instructions (primary manual) Operating Instructions Manual

the receiver and the remote is different, you
cannot operate the receiver with the remote. For
the command mode of the remote, refer to the
operating instructions supplied with the remote.
To switch the command mode of the receiver,
press ?/1 while pressing INPUT MODE. Each
time you press ?/1, the command mode switches
between "C.MODE [AV2]" and "C.MODE
[AV1]". (The initial setting is "C.MODE
[AV2]".)
• Make sure you select the correct input on the
remote.
* Models of area code CEL only.

Error messages

If there is a malfunction, the display shows a
code of two numbers and a message. You can
check the condition of the system by the
message. Refer to the following table to solve
the problem. If any problem persists, consult
your nearest Sony dealer.
DECODE ERROR/CHECK CODE 01
Appears when the signal which the receiver cannot
decode (ex. DTS-CD) is input when "DEC. PRI." in
the CUSTOMIZE menu is set to "PCM". Set to
"AUTO".
PROTECTOR/CHECK CODE 11
Irregular current output to the speakers. Turn off the
receiver and check the speaker connection. Then
turn on the power again.
PROTECTOR/CHECK CODE 12
The amplifier section is overheated. Turn off the
receiver and check that the ventilation hole is not
covered. Leave the receiver for a while and turn on
the power again.
PROTECTOR/CHECK CODE 13
The power supply section is overheated. Turn off
the receiver and check that the ventilation hole is not
covered. Leave the receiver for a while and turn on
the power again.
PROTECTOR/CHECK CODE 21
Turn off the receiver and consult your nearest Sony
dealer.
PROTECTOR/CHECK CODE 22
There is a problem with the power circuit. Turn off
the receiver and check the speaker connection. Then
turn on the power again.
GB
54
Reference sections for clearing
the memory
To clear
All memorized settings
Customized sound fields
See
page 19
page 39