Storing Fm Stations Automatically; Autobetical; (Models Of Area Code Cel Only) - Sony STR-DA2000ES Operating Instructions (primary manual) Operating Instructions Manual

Direct tuning
Enter a frequency of the station directly by using
the numeric buttons on the remote.
For details on the supplied remote, refer to the
operating instructions supplied with the remote.
1
STR-DA2000ES:
Move the easy scroll key to select
"TUNER", then press the key
repeatedly to select "FM" or "AM".
STR-DB2000:
Press TUNER on the remote repeatedly
to select FM or AM.
You can also use INPUT SELECTOR on
the receiver.
2
Press ALT, then press D.TUNING on
the remote.
3
Press the numeric buttons to enter the
frequency.
Example 1: FM 102.50 MHz
Press 1 b 0 b 2 b 5 b 0
Example 2: AM 1,350 kHz
Press 1 b 3 b 5 b 0
(You do not have to enter the last "0" when
the tuning scale is set to 10 kHz.)
If you have tuned in an AM station, adjust
the direction of the AM loop antenna for
optimum reception.
If you cannot tune in a station
and the entered numbers flash
Make sure you have entered the right frequency.
If not, repeat step 3. If the entered numbers still
flash, the frequency is not used in your area.
GB
26
Storing FM stations
automatically

— AUTOBETICAL

(Models of area code CEL only)

This function lets you store up to 30 FM and FM
RDS stations in alphabetical order without
redundancy. Additionally, it only stores the
stations with the clearest signals.
If you want to store FM or AM stations one by
one, see "Presetting radio stations".
1
Press ?/1 to turn off the receiver.
2
Hold down MEMORY/ENTER and press
?/1 to turn the receiver back on.
"Autobetical" appears in the display and the
receiver scans and stores all the FM and FM
RDS stations in the broadcast area.
For RDS stations, the tuner first checks for
stations broadcasting the same program,
then stores only the one with the clearest
signal. The selected RDS stations are sorted
alphabetically by their Program Service
name, then assigned a 2-character preset
code. For more details on RDS, see
page 28.
Regular FM stations are assigned 2-
character preset codes and stored after the
RDS station.
When done, "Finished" appears in the
display momentarily and the receiver
returns to the normal operation.
Notes
• Do not press any button on the receiver or supplied
remote during autobetical operation, except ?/1.
• If you move to another area, repeat this procedure to
store stations in your new area.
• For details on tuning the stored stations, see "Tuning
to preset stations".
• If you move the antenna after storing stations with
this procedure, the stored settings may no longer be
valid. If this happens, repeat this procedure to store
the stations again.