Adjusting The Equalizer; Advanced Settings - Sony STR-DA2000ES Operating Instructions (primary manual) Operating Instructions Manual

Adjusting the equalizer

You can adjust the tonal quality (bass, treble
level) of each speaker using the EQUALIZER
menu.
Bass
Level
(dB)
1
Start playing a source encoded with
multi channel surround effects (DVD,
etc.).
2
Press MAIN MENU to select
"EQUALIZER".
3
Rotate MENU to select the parameter.
For details, see "EQUALIZER menu
parameters" below.
4
While monitoring the sound, rotate –/+
to adjust the selected parameter.
5
Repeat steps 3 and 4 to adjust the other
items.
Note
You cannot adjust the equalizer when the system is
decoding PCM 96 kHz signals, or when DTS 96/24,
DTS-ES Matrix or DTS Neo:6 decoding is applied.
EQUALIZER menu parameters
x EQ
Initial setting: OFF
Select "ON" to activate the equalizer.
x BASS XXX.X dB
(Front speaker bass level)
x TREBLE XXX.X dB
(Front speaker treble level)
Initial setting: 0 dB
You can adjust from –10 dB to +10 dB in 1 dB steps.
GB
40

Advanced settings

Using the CUSTOMIZE menu
to adjust the receiver
Treble You can adjust various receiver settings using
the CUSTOMIZE menu.
1
Press MAIN MENU to select
"CUSTOMIZE".
2
Rotate MENU to select the parameter.
For details, see "CUSTOMIZE menu
parameters" below.
3
Rotate –/+ to adjust the selected
parameter.
4
Repeat steps 2 and 3 to adjust the other
items.
CUSTOMIZE menu parameters
The initial setting is underlined.
x MENU EXP. (Menu expanding)
• ON
The advanced parameters for the SP. SET UP and
LEVEL menus are displayed and can be adjusted.
For details on each setup item, see pages 20, 38 and
the following pages.
• OFF
The advanced parameters are not displayed.
x DTS 96/24 (DTS 96/24 decoding mode)
• AUTO
When a DTS 96/24 signal is input, it is played back
at 96 kHz sampling frequencies.
• OFF
Even when a DTS 96/24 signal is input, it is played
back at 48 kHz sampling frequencies.
Notes
• This parameter is valid only in the A.F.D. mode
(page 32). In other sound fields, this parameter is
always set to "OFF".
• DTS 96/24 decoding is only valid in the A.F.D. mode
(page 32). When the system is set to other sound
fields, standard 48 kHz decoding is used.
Even when a DTS 96/24 signal is input, standard 48
kHz decoding is used if any speakers are set to
"SMALL" or if the sub woofer is set to "NO".