Yaesu FT3DR Instruction Manual page 8

The WIRES-X DG-ID setting screen will be displayed.
2
Rotate the DIAL knob to set the WIRES-X DG-ID to the same ID number as the node
station.
AUTO: Only open nodes, set to the DG-ID number "00" may be connected.
01 to 99: Only nodes matching the set DG-ID number may be connected.
3
Press the PTT.
Returns the screen to the frequency display screen.
4
Rotate the DIAL to set the A-band to the frequency of the desired local node.
Caution
WIRES-X can only be used on the A-band.
If using the B-band (shown on the bottom part of the screen) as the operation band, pressing the [ X ]
key automatically switches the operation band to the A-band (shown on the top part of the screen).
5
Press the [ X ] key.
[ X ] flashes on the left side of the frequency display.
• While [ X ] is flashing, briefly press the [ X ] key to re-establish connection to the local node.
Tip
• When any local node cannot be found, [ X ] will disappear in 30 seconds.
When a local node is found, [ X ] is lit solid, and the node name and city name appear
on the bottom part of the screen.
Tip Depending on the connection status, the screen will show one of four display patterns.
(1) Connected to the local node, but unable to connect
to Internet nodes or rooms (never before established
connection to Internet nodes or rooms)
(2) Connected to the local node, but unable to connect
to Internet nodes or rooms (previously succeeded in
establishing connection to Internet nodes or rooms)
8
JQ1YBG-ND1 Shinagawa-
SEARCH & DIRECT
JQ1YBG-ND1 Shinagawa-
SEARCH & DIRECT
JA1YOE-ROOM12345