Kenmore 795.583*.410 Service Manual page 8

2. INSTALL WATER FILTER
It is recommended that you replace the water filter:
• Approximately every 6 months.
• When the water filter indicator turns on.
• When the water dispenser output decreases.
• When the ice cubes are smaller than normal.
1. Remove the old water filter.
Press the push button to open the
water filter cover.
NOTE: Replacing the water filter causes
a small amount of water (around 1 oz. or
25 cc) to drain. Place a cup under the
front end of the water filter cover to
collect any leaking water. Hold the water
filter upright, once it is removed, to prevent any remaining
water from spilling out of the water filter.
Pull the water filter downward and
pull out. Make sure to rotate the filter
down completely before pulling it out
of the manifold hole.
2 . Replace with a new water filter.
Take the new water filter out of its
packing and remove the protective
cover from the o-rings. With the
water filter tabs in the horizontal
position, push the new water filter
into the manifold hole until it stops.
Rotate the water filter up into
position and close the cover.
The cover will click when closed
correctly.
3. After the water filter is replaced, dispense 2.5 gallons of
water (flush for approximately 5 minutes) to remove trapped
air and contaminants from the system. Do not dispense the
entire 2.5 gallon amount continuously. Depress and release
the dispenser pad for cycles of 30 seconds ON and 60
seconds OFF.
NOTE: To purchase a replacement water filter, visit a Sears
store or call 1-800-4-MY-HOME®. You may also order on-line
at www.sears.com/partsdirect.
3. REFRIGERATOR/FREEZER SHELVES
The shelves in your refrigerator and freezer are adjustable to
meet your individual storage needs. Adjusting the shelves to fi t
items of different heights will make finding the exact item you
want easier. Doing so will also reduce the amount of time the
refrigerator doors are open which will save energy.
IMPORTANT: Do not clean glass shelves with warm water while
they are cold. Shelves may break if exposed to sudden
temperature changes or impact.
NOTE: Glass shelves are heavy. Use special care when
removing them.
Detaching the shelf
Remove all items from the shelf. Lift the front of the shelf slightly
to disengage the rail stops.
Pull the shelf forward about halfway, keeping the front of the
shelf slightly lifted.
Holding the shelf with both hands, tilt the shelf and pull it out.
Assembling the shelf
Tilt the front of the shelf up and guide the shelf into the slots at a
desired height. Slide the shelf in then lower the front of the shelf.
CAUTION: Make sure that shelves are level from one side to the
other. Failure to do so may result in the shelf falling or spilling
food
8