Table of Contents
Advertisement
S4 Beam Sensor & brackets
Brackets
How to adjust the Parallel bracket
To adjust the parallel bracket follow these procedures:
Y
Metal box
X
Adjustable
Y
plate
Lock nuts
Ensure the lock nuts are opened out.
To
tilt the 'adjustable plate' in the 'Y' axis towards the bottom:
In small movements unscrew the
and at the same time screw down the
To tilt the 'adjustable plate' in the 'Y' axis towards the top:
In small movements screw down the
and at the same time unscrew the
#
On completion secure the adjustment by the two
using a 7mm nut driver.
To tilt the 'adjustable plate'
In small movements screw down the
and at the same time unscrew the
To tilt the 'adjustable plate' in the 'X' axis towards the right hand side:
In small movements unscrew the
and at the same time screw down the
#
On completion secure the adjustment by the two
using a 7mm nut driver.
#
Hold the
locked to retain the setting.
4188-968 issue 4_Part 2_07-12_S4 mains interface
Adjusters
The parallel bracket shown is without
the base and sensor fitted for clarity
'Y' axis
X
'X' axis
in the 'X' axis
adjuster
in place to prevent movement while it is being
Commissioning information
o
Up to ± 8 adjustment is
possible in the X and Y axis.
j
top
Y
adjuster
bottom
Y
adjuster
j
top
Y
adjuster
bottom
Y
adjuster
lock nuts
towards the left hand side:
l
left
X
adjuster
m
right
X
adjuster
l
left
X
adjuster
right
X
adjuster
lock nuts
k
k
Y,
m
X,
5
Advertisement
Table of Contents
