Table Of Contents - Honeywell GENT S4 Data And Installation

Table of Contents

Technical Data1
Data And Installation2
Do's And Dont's2
S4 Beam Sensor & Brackets3
Test Keyswitch3
How To Install An Angle Bracket And Fit A Beam Sensor3
How To Pre-Assemble The Parallel Bracket4
How To Install A Parallel Bracket And Fit A Beam Sensor4
Commissioning Checks5
Compatibility5
Backward Compatibility5
How To Align A Beam Sensor Pair6
Overall Process To Align Beam Sensor Pair6
Commissioning Information8
Procedure For Nano Panel8
Brackets9
How To Adjust The Parallel Bracket9
How To Adjust The Angle Bracket10
To Adjust The Angle Bracket Follow These Procedures10
Alignment Angles11
Light Shield12
How To Fit A Light Shield12
How To Interpret Operational Indications At A Beam Sensor12
Find Device13
How To Find A 'Beam Receiver' Or 'Beam Transmitter'13
Beam Sensor States14
States Verses Distance14
Lpcb Approval14
How To Set Up A Beam Sensor State15
Procedure For Vigilon Panel (Access Level 3)15
Procedure For Nano Panel (Access Level 3)15
Time Averages16
How To Read The Time Average Values Of A Beam Sensor16
Gain Value17
Procedure For Vigilon Panel17
Test18
How To Test A Beam Sensor Pair18
Commissioning Tool19
Vigilon - Commissioning Tool19
Nano - Commissioning Tool19
S4 Beam Programming Base Interface21
How To Change The Mode Of An S4 Beam21