Table of Contents
Advertisement
HEATFLOW CONVECTION KIT INSTALLATION
The wood burning fireplace is approved for use with a Heatflow Convec-
tion Kit (hot air ducting system).
KIT CONTENTS (See Figure 22):
The Ducted Flex Kit must use both hot air outlets and includes:
2 ea. Wall Thimble Assembly (item #1)
2 ea. Duct Adaptor (item #2)
2 ea. Duct Ring (item #3)
8 ea. #6-18 X 2 Drywall Screw (item #4)
22 ea. #10-16 X 3/4" Hex-Unslotted Drive Zinc Finish
Self-Drilling Screw (item #5)
2 ea. 2 Ply 8" Dia. X 10' Aluminum Flex with R4 Insulated Sleeve (item #6)
2 ea. Grill, White (item #7)
4 ea. #6-18 X 1-1/2 White Oval Head Zinc Plated Phillips Screws (item #8)
1 ea. Instruction Sheet
(Item #5)
#10-16 X 3/4" Hex-Unslotted
Drive Zinc Finish Self-Drilling
Screw (Qty 22)
(Item #3)
Duct Ring
(Qty 2)
(Item #2)
Duct Adaptor
(Qty 2)
Detail B
Figure 22 - General Assembly
(Item #6)
2 Ply 8" Dia X 10' Aluminum Flex With
R4 Insulated Sleeve (Qty 2)
See Detail B
Fireplace
NOTE: DIAGRAMS & ILLUSTRATIONS ARE NOT TO SCALE.
EPA Fireplace - HeatFlo Convection Kit
Cat. No.
Model
F3790
EPA-HEATFLO-KIT
Table 3
TOOLS NEEDED:
5/16" hex driver and no. 2 Phillips screwdriver
GENERAL INFORMATION
If you encounter any problems, need clarification of these instructions
or are not qualified to properly install this kit, contact you local distribu-
tor or dealer.
Read this instruction sheet in its entirety before beginning the installation.
ALL WARNINGS AND PRECAUTIONS IN THE INSTALLATION AND
OPERATION MANUAL PROVIDED WITH THE APPLIANCE APPLY TO
THESE INSTRUCTIONS.
TURN OFF THE APPLIANCE AND ALLOW IT TO COMPLETELY COOL
BEFORE PROCEEDING.
Head Zinc Plated Phillips
Screw (Qty 4)
(Item #4)
#6-18 X 2" Drywall
(Qty 8)
(Item #1)
Wall Thimble
Assembly
(Qty 2)
Front
Description
EPA Heatflo Conv. Kit
See Detail A
(Item #8)
#6X1-1/2 White Oval
(Item #7)
Grill White (Qty 2)
Detail A
17
Advertisement
Table of Contents
