Table of Contents
Advertisement
Chapter 3. System
Network:
The destination IP network or host address of this route. Valid format is dotted
decimal notation or a valid IPv6 notation. A default route can use the value
0.0.0.0 or IPv6 :: notation.
Mask Length:
The destination IP network or host mask, in number of bits (prefix length). It
defines how much of a network address that must match, in order to qualify for
this route. Valid values are between 0 and 32 bits respectively 128 for IPv6
routes. Only a default route will have a mask length of 0 (as it will match
anything).
Gateway:
The IP address of the IP gateway. Valid format is dotted decimal notation or a
valid IPv6 notation. Gateway and Network must be of the same type.
Next Hop VLAN (Only for IPv6):
The VLAN ID (VID) of the specific IPv6 interface associated with the
gateway.
The given VID ranges from 1 to 4094 and will be effective only when the
corresponding IPv6 interface is valid.
If the IPv6 gateway address is link-local, it must specify the next hop VLAN
for the gateway.
If the IPv6 gateway address is not link-local, system ignores the next hop
VLAN for the gateway.
Buttons
Add Interface:
Click to add a new IP interface. A maximum of 8 interfaces is supported.
Add Route:
Click to add a new IP route. A maximum of 8 routes is supported.
Apply:
Click to save changes.
Reset:
Click to undo any changes made locally and revert to previously saved values.
27
Advertisement
Table of Contents
