Programming The Remote Control - Sony KP 46WT520 Operating Instructions Manual

Programming the Remote Control

46
The remote control is preset to operate Sony brand video equipment.
If you have video equipment other than Sony brand that you want to
control with the TV's remote control, use the following procedure to
program the remote control.
✍
The equipment must have infrared (IR) remote capability in order to be used
with the remote control.
1
Turn to the list of "Manufacturer's Codes" on page 47, and find
the three-digit code number for the manufacturer of your
equipment. (If more than one code number is listed, try the
number listed first.)
2
While holding down
. Then release both buttons. (The
RESET
SAT/CABLE FUNCTION
3
Press either
DVD/VCR FUNCTION
which button you want to program.
4
Enter the three-digit manufacturer's code number.
5
Press .
ENT
✍
You must do step 5 within 10 seconds of step 4, or you must redo
steps 3 through 5.
6
To check if the code number works, aim the TV's remote control
at the equipment and press the
with that equipment. If it responds, you are done. If not, try using
another code listed for that manufacturer.
Notes
❑
If more than one code number is listed, try entering them one by
one until you come to the correct code for your equipment.
❑
If you enter a new code number, the code number you previously
entered at that setting is erased.
❑
In some cases, you may not be able to operate your equipment
with the supplied remote control. In such cases, use the
equipment's own remote control.
❑
Whenever you remove the batteries to replace them, the code
numbers may revert to the factory setting and must be reset.
or
DVD/VCR FUNCTION
DVD/VCR FUNCTION
buttons will flash.)
or
SAT/CABLE FUNCTION
button that corresponds
POWER
, press
SAT/CABLE FUNCTION
and
, depending on