Programming The Remote Control - Sony GRAND WEGA KDF-E42A10 Operating Instructions Manual

Watching the TV
Programming the Remote Control
The remote control is preset to operate Sony brand video equiplnent.
DVR 772
DVD/VCR 601 (Sony Drealn System)
SAT/CABLE 801 (Sony Satellite Receiver)
Follow tile steps below to program your TV's relnote control to operate tile
non-Sony video equipment.
ii - 'S
Find tile three-digit
code for your equipment
fiTom the Manutacturer .'
Codes" listed on page 48. If more than one code number is listed, try
entering from the code listed first.
_'D,' S_T,'
[] Press and hold the _, _ or _ FUNCTION button you want to
prograln on the remote control and press the _ button simultaneously.
The selected FUNCTION button (DVR, DVD/VCR or SAT/CABLE)
will flash.
[] Enter the three-digit manufacturer's code number using the (_)-(_)
buttons while the button is lit. If code is not entered within 10 seconds,
you must perform step 1 again.
[] Press @ button.
When the programming is correct, the selected FUNCTION button will
flash twice, and when not, flashes five times.
To check if the code works
Aim your TV's remote control at the equipment, and press the green
button. If the equipment turns on and off, the programming is completed. If
not, try the next code listed.
,2"7 If no code is input within the above specified time, or an invalid or
incorrect code number is input, the remote control automatically
goes back to the previous setting.
,2"7 In some cases, you may not be able to program your remote
control to operate other equipment. In such cases, use the
equipment's own remote control.
Z7 Using dead batteries or removing the batteries may cause the
programmable codes to be lost and revert back to factory settings.
Reprogramming the codes may be necessary.
47