HP ProBook x360 11 G4 Education Edition Maintenance And Service Manual page 34

7. Loosen the sides (2) and top (3) to completely disengage the top cover from the bottom cover.
8.
Lift the front edge of the keyboard/top cover up and back until the webcam module cable, touchpad
cable, and keyboard cable connectors are accessible.
IMPORTANT:
so much as to inadvertently disconnect the cables, as doing so could damage the cables and/or
connectors.
9. Disconnect the keyboard cable from the zero insertion force (ZIF) connector on the system board (1).
10. Disconnect the touchpad cable from the ZIF connector on the system board (2).
11. Disconnect the webcam cable from the ZIF connector on the system board (3).
12.
Remove the keyboard/top cover.
Reverse this procedure to install the keyboard/top cover.
26 Chapter 5 Removal and replacement procedures for Authorized Service Provider parts
The top cover is connected to the system board by three cables. Do not lift the top cover