Signallings; Structure Of The; Diagnosis Bar - ABB SACE Emax 2 Series Instructions For Use Manual

Signallings The following table provides a description of the signals of the interface:
Structure of the pages The following table shows how the pages shown on the display are structured:
Diagnosis bar The diagnostics bar is present in the main page and level 2 pages, along the lower side of the display, and its
7 | © 2018 ABB | 1SDH001316R0002 - ECN000086018 - Rev. C
LEDs Description
The possible states are:
• Off: power supply absent.
• On, fixed or flashing: power supply present, and trip unit on.
Green
NOTE: if the trip unit is off and no opening has taken place, if you press the iTEST key
the LED comes on for 6 s.
The possible states are:
• Off: no warning or error.
• On, blinking rapidly: absence of communication between trip unit and Mainboard, or
Yellow installation error (of the Rating Plug, or the Ekip Measuring module, or Ekip Measuring Pro).
• On, flashing slowly: internal error.
• On, with two quick flashes every 0.5 s: parametrization error.
• On, fixed: prealarm of protection L, or circuit-breaker state error.
The possible states are:
• Off: no alarm or error.
• On, blinking rapidly: absence of communication between trip unit and Mainboard, or trip coil
Red disconnected, or current sensor disconnected, or delay active.
• On, with two quick flashes every 2 s: rating plug error.
• On, flashing slowly: internal error.
• On, fixed: tripping signal.
Level 1

Diagnosis bar

Main page
function is to display the messages.
The bar appears as follows:
Figure 3
Level 2
Alarm list page
Histograms page
Menu page
Measuring instruments pages
Measurements pages
TC disconnected
Ekip Touch protection trip unit | 1 - Layout of the interface
ABB | SACE Emax 2
Level 3
Protections menu
Advanced menu
Measurements menu
Settings menu
Test menu
About menu
Continued on the next page