Mechanical Installation; Installation Position And Distance; Single Drive Installation - YASKAWA CIPR-GA70C Series Initial Steps

9 Mechanical Installation

9 Mechanical Installation
WARNING
Fire Hazard. Do not put flammable or combustible materials on top of the drive and do not install the drive
near flammable or combustible materials. Attach the drive to metal or other noncombustible material. Failure to obey can cause
death or serious injury.
CAUTION
Crush Hazard. Do not hold the drive by the front cover or terminal cover. Tighten the screws correctly before
moving the drive. Failure to obey can cause minor to moderate injury.
Note:
Observe all necessary conditions to safely and correctly install the AC drive. Refer to the Technical Manual for more information.
NOTICE
Install the drive as specified by EMC Guidelines. Failure to obey can cause incorrect operation and damage to
electrical devices.
◆

Installation Position and Distance

Install the drive vertically for sufficient cooling airflow.
Note:
Contact Yaskawa or a Yaskawa representative for more information about installing drive models on their side.
A - Vertical installation
■

Single Drive Installation

Use the clearances specified in
and airflow.
A - 50 mm (2 in.) minimum
B - 30 mm (1.2 in.) minimum on both
■
Install Drives Side-by-Side
Users can install drive models 2004xB to 2082xB and 4002xB to 4044xB side-by-side.
Install the drives as specified by
Mounting].
Derate the output current to align with the ambient temperature.
Install other drive models as specified by
EN 12
Figure 9.1 Installation Position
Figure 9.2 to install the drive. Make sure that there is sufficient space for wiring
sides
Figure 9.2 Installation Distances for One Drive
Figure 9.3. Set L8-35 = 1 [Installation Method Selection = Side-by-Side
Figure 9.2
B - Horizontal installation
C - 120 mm (4.7 in.) minimum above
and below
D - Airflow direction
YASKAWA ELECTRIC TOEP C710617 17D YASKAWA AC Drive GA700 Initial Steps