Troubleshooting - Bissell 3593 User Manual

Troubleshooting

Vacuum cleaner won't run
Possible Causes
Power cord not plugged in
1
Blown fuse/tripped breaker
2
Vacuum cleaner or Tools won't pick up dirt
Possible Causes
Incorrect Height Adjustment
1
Hose not attached to suction opening
2
Twist 'n Snap Hose not securely attached
3
4 Crack or hole in Hose
5 Broken or worn Drive Belt
Rotating Floor Brush bristles worn
6
Rotating Floor Brush jammed
7
Clog in vacuum
8
Dirt Container full
9
Dirt Container or Upper Tank not installed properly
10
Filters are dirty
11
Vacuum cleaner is difficult to push
Possible Causes
Incorrect Height Adjustment
1
Visible dirt escaping from cleaner
Possible Causes
Dirt Container full
1
2 Filters missing or installed incorrectly
Dirt Container installed incorrectly
3
Clean Carpet Sensor not functioning properly
Possible Causes
Clean Carpet Sensor Lens is Dirty
1
2 Clog in Suction Intake Area
14
WARNING:
To reduce the risk of injury from moving
parts and/ or electrical shock, turn Power
Switch OFF and disconnect polarized plug
from electrical outlet before performing
troubleshooting checks.
Remedies
Check electrical plug
1
Check/Replace fuse or reset breaker
2
Remedies
Adjust Powerfoot to correct height
1
Firmly push Hose Wand into the suction opening
2
Make sure Twist 'n Snap Hose is snapped into
3
locked position
4 Check Hose and replace if needed
5 Replace Drive Belt, see page 12
Replace brush
6
Remove brush and clean debris from brush ends
7
Clear clog, see pages 12-13
8
Empty Dirt Container
9
Position correctly and lock in place
10
Check and clean Upper Tank,
11
Pre-Motor and Post-Motor Filters
Remedies
Adjust Powerfoot to correct height setting
1
Remedies
Empty Dirt Container
1
Check Upper Tank, Pre-Motor and Post-Motor
2
Filters for correct installation
Pull out and re-insert Dirt Container correctly
3
Remedies
Clean Internal Sensor Lens, see page 10
1
2 Clear clog, see pages 12-13