Replace Drive Belt; Replace Lightbulb - Bissell 3593 User Manual

Check Rotating Floor Brush and Drive Belt Continued
Grasp Rotating Floor Brush at both ends and lift.
4.
Clean strings, hair and other debris from Rotating Floor
5.
Brush, paying particular attention to brush ends.
Clean strings, hair and other debris from Motor Pulley and
6.
Drive Belt areas.
Check Drive Belt carefully for wear, cuts or stressed areas.
7.
Check Air Passageway for obstructions. Remove debris
8.
from this area.

Replace Drive Belt

Unplug cleaner from electrical outlet.
1.
With Rotating Floor Brush removed from vacuum cleaner
2.
(Steps 1-4 of check Rotating Floor Brush and Drive Belt),
grasp old Drive Belt and remove from Motor Pulley.
Discard old Drive Belt.
Place new Drive Belt over Motor Pulley and stretch other end
3.
over Rotating Floor Brush in the space between the bristles.
Place ends of Rotating Floor Brush down into slots on
4.
sides as shown.
Turn Rotating Floor Brush by hand several times in the
5.
direction of Motor Pulley. If properly installed, Drive Belt
will center itself on Rotating Brush crown.
Reposition Brush Cover and screw or snap back into place.
6.
Check to be sure all screws or latches are secure.

Replace Lightbulb

Unplug cleaner from electrical outlet.
1.
Using a screwdriver, remove the two screws as shown
2.
and lift off the lens.
Remove the bulb from the socket by pushing in gently
3.
and turning it counterclockwise. Install the new bulb by
pushing it gently into the socket and turning clockwise.
Reposition lens and secure with the two screws.
4.
Maintaining Optional TurboBrush
Select Models Only
The TurboBrush should be checked regularly for clogs
or debris wrapping around the brush roll.
Unplug vacuum from electrical outlet.
1.
If a clog is present or debris is visible, unscrew the two
2.
screws on the back of the TurboBrush to remove the
faceplate and clear any obstructions.
To clean debris from the brush roll, remove the screw
3.
located by the brush roll with a Phillips head screwdriver.
Lift the belt cover. Remove the brush roll from the drive
belt and clean debris.
12
Motor Pulley
Air Passageway