Table of Contents
Advertisement
1-5. REPLACEMENT OF
MOTOR (Continued)
1-6. REPLACEMENT OF
SWITCH
1-4
5. Loosen the hex nuts on the adjustable foot (10), loosen belt, and
then remove belt.
6. Remove the hinge pin from hinge (7) and remove motor (8).
7. Remove the wiring cover plate from the motor and disconnect wires
from motor.
When wiring new motor leads, refer to the wiring diagram in this
manual. The motor must rotate in a counterclockwise direction, or
damage to the unit could result.
8. Transfer bolts (5), nuts (2), lockwashers (3), and hinge to new
motor and install.
9. Reassemble in reverse order of above procedures.
To avoid loose connections and possible component damage, wire nut
connections must be tight and secured with electrical tape.
To avoid electrical shock or property damage, move the
power switch to OFF and disconnect main circuit breaker,
or unplug cord at wall receptacle.
1. Remove all equipment from top of unit.
2. Remove top (28) by lifting from unit.
3. Remove two screws (17) from cover plate assembly.
4. Remove the switch mounting nut, switch on/off plate and switch
guard.
5. Place wires on new switch exactly as on old switch.
6. Replace switch nut, on/off plate, and switch guard, and tighten.
203
Advertisement
Table of Contents
