Table of Contents
Advertisement
1-3. REPLACEMENT OF BELT
1-4. REPLACEMENT OF
MANDREL
1-2
1. Remove all equipment (breading lugs, back splash, dip pot, etc.)
from top of unit.
2. Remove top (28) by lifting from unit.
3. Using a #2 Phillips screwdriver, remove two screws (17) from
cover plate assembly (16), and slide cover plate assembly out
towards the sifter basket.
4. Using a 1/2" wrench, loosen the hex nuts on the adjustable foot
(10) so that the motor (8) can be moved to loosen the belt (1).
5. Replace belt and adjust tension.
Proper tension is achieved when belt deflects approximately 1/2"
(12.7 mm).
To avoid electrical shock or property damage, move the power
switch to OFF and disconnect main circuit breaker, or unplug cord
at wall receptacle.
1. Remove all equipment from top of unit.
2. Remove top (28) by lifting from unit.
3. Remove two screws (17) from cover plate assembly (16) and slide
assembly out towards the sifter basket.
203
Advertisement
Table of Contents
