Sony ZS-M35 Primary Operating Instructions Manual page 48

Labeling recordings (Name function) (continued)
Tip
When using an MD
that has been already
labeled, a disc name or
a track name appears in
the display at the time
of labelling. Change the
name according to step
3 on page 45, if
necessary, then press
YES• ENTER to
confirm the new name.
48
Editing recorded tracks on the MD
Labeling after recording
To label an MD or a track, operate as follows. You can
input up to 100 characters for each label.
1
When you label an MD, insert the MD you want to
label and stop operation.
When you label a track, play the track you want to
label.
2
Press EDIT repeatedly until "Disc Name" or
"Track Name" appears in the display, and press
YES•ENTER.
When you label an MD, select "Disc Name".
When you label a track, select "Track Name".
3
Label the MD or the track according to steps 3 and
4 on page 45.
4
After completing an entire name, press YES•
ENTER.
The name is labeled on the MD.
To change the name
According to step 1 on this page, make the disc name
or the track name you want to change appear in the
display. Replace the old name with a new one, and
press YES•ENTER.