JVC RX-DP10VBK Service Manual page 13

<Front panel assembly section>
Removing the FL display board & front AV
in board
Prior to performing the following procedure, remove
the top cover and the front panel assembly.
1. Pull out the volume knob on the front side of the front
panel assembly and remove the nut attaching the FL
display board.
2. Disconnect the harness from the connector CN973
on the front AV in board.
3. Remove the three screws A attaching the front AV in
board.
4. Remove the nine screws B attaching the FL display
board on the back of the front panel.
5. Disconnect the harnesses from connector CN969,
CN975 and CN982 on the FL display board.
Removing the power switch board &
motor assembly
Prior to performing the following procedure, remove
the front panel assembly and the FL display board.
1. Remove the four screws C attaching the power
switch board.
2. Remove the three screws D attaching the motor
assembly on the back of the front panel.
3. Remove the belt and the two screws a attaching the
motor.
Removing the door input board
Prior to performing the following procedure, remove
the front panel assembly and the FL display board.
Remove the four screws E attaching the door and
1.
remove the door from front panel assembly.
Remove the six screws F attaching the door input
board.
2.
(See Fig.1 and 2)
(See Fig.3)
CN973
(See Fig.3 and 4)
Operation switch panel
Door
Fig.1
FL display board
Front AV in board
CN982
A B
Fig.2
Power switch
board
E
Door
Fig.3
F
Door input board
Fig.4
RX-DP10VBK/RX-DP10VSL
RX-DP10RSL
Nut
Front panel assembly
Volume knob
CN969
CN975
B
C
E
D
Belt
Motor assembly
Door
a
1-13