Removing The Fan Motor - JVC RX-DP10VBK Service Manual

RX-DP10VBK/RX-DP10VSL
RX-DP10RSL
Removing the head phone board
Prior to performing the following procedures, remove
the top cover, rear panel and front panel assembly.
1. Disconnect the harnesses from the connector CN981
on the system control board (see fig.5) and CN738
on the power amp. board.
2. Removing the nut L fixing the head phone board.
3. Removing the screw M attaching the earth wire and
bracket.
Harness band
Removing the power amp. assembly
Prior to performing the following procedures, remove
the top cover, rear panel, front panel assembly,
system control board, DSP board, shield cover,
audio signal 1 board, audio signal 2 board, video
board, s video board and input base board.
1. Remove the three screws N fixing the barriers, and
remove the tow barriers.
2. Remove the eight screws O attaching the power
amp. assembly.
3. Pull up the power amp. assembly.

Removing the fan motor

Prior to performing the following procedures, remove
the top cover and rear panel.
1. Disconnect the harness from the connector CN65 on
the power supply 1 board (see fig.16).
2. Removing the four screws P attaching the fan motor.
1-10
(See Fig.20 and 21)
CN738
(See Fig.21 and 22)
(See Fig.23)
Earth wire
M
Fig.20
Barrier
N
(Front side)
Fig.21
Barrier
O
Fig.22
Fig.23
Bracket
L
Head phone
board
O
Power
amp.
assembly
Power
amp.
board
O
N
(Rear side)
Fan motor
P