Ip Parameters - Siemens SIRIUS 3RW5 Manual

6.2.1.3

IP parameters

All EtherNet/IP devices use the TCP/IP protocol and therefore need an IP address to operate
on EtherNet/IP.
IP parameters
● IP address
● Subnet mask
● Router address
Temporary IP parameters
If you activate the BOOTP/DHCP server (Page 46) in the TCP/IP Interface Object
(Page 104), the 3RW5 EtherNet/IP communication module restarts without a valid IP
address and resends BOOTP/DHCP messages.
Note the settings in the configuration software of the controller.
Note
Set static IP parameters
Static IP parameters that have previously been set are overwritten and deleted by temporary
IP parameters.
Static IP parameters
The IP parameters set on the 3RW5 soft starter or transferred online are stored retentively in
the 3RW5 communication module. The IP parameters of the 3RW5 communication module
must match the IP parameters in the configuration.
When assigning the IP parameters online, note the settings in the configuration software of
the controller.
Note
Restarting the communication interface
Any change in the IP parameters via SIRIUS Soft Starter ES (TIA Portal) requires a restart of
the communication interface.
The restart interrupts all of the EtherNet/IP connections and re-establishes them.
SIRIUS 3RW5 EtherNet/IP communication module
Manual, 05/2019, A5E45131885002A/RS-AA/001
6.2 Configuring the 3RW5 soft starter
Configuring
45