Cc-Link Parameter Settings; Cc-Link Station Information Settings - Mitsubishi Electric Melsec-QS Series Safety Application Manual

5
SAFETY APPLICATION CONFIGURATION EXAMPLE

5.3 CC-Link Parameter Settings

Set the CC-Link parameters as follows.
For the definition or setting range of each parameter, refer to the following manual.
Module
Start I/O No.
Operational setting Case of CPU STOP setting
Mode
Transmission speed
Safety refresh monitoring time
Link ID
All connect count
Remote input (RX)
Remote input (RY)
Remote register (RWr)
Remote register (RWw)
Special relay (SB)
Special relay (SW)
Retry count
Automatic reconnection station count
Station information setting
Station information
Safety remote station
setting
settings
Remote device station initial setting

5.3.1 CC-Link station information settings

Set the CC-Link station information settings as follows.
Module Station No.
1/1
Master (1) 2/2
3/3
Module Station No.
Master (2) 1/1
5
5.3 CC-Link Parameter Settings
- 4
5.3.1 CC-Link station information settings
CC-Link Safety System Master Module User's Manual QS0J61BT12
Table5.2 CC-Link parameter setting example
*1
Safety remote net(Ver. 1 mode)
*1: Fixed to "Clears compulsorily" when the safety CPU operation mode is set to SAFETY MODE.
POINT
POINT
Make the same settings between the link ID and transmission speed in the CC-
Link parameter of GX Developer and those of the switches on remote I/O main
module to be connected.
Table5.3 Setting example of master (1) station information /
Station type
Safety remote I/O station
Safety remote I/O station
Safety remote I/O station
Table5.4 Setting example of master (2) station information
Station type
Safety remote I/O station
Master (1)
00H
Clears compulsorily
2.5Mbps
300ms
0
3
X100
Y100
–
–
SB0
SW0
3
1
Section 5.3.1
Section 5.3.2
None
Exclusive station count
Exclusive station 1
Exclusive station 1
Exclusive station 1
Exclusive station count
Exclusive station 1
Master (2)
20H
Clears compulsorily
Safety remote net(Ver. 1 mode)
2.5Mbps
300ms
1
1
X200
Y200
–
–
SB200
SW200
3
1
None
Reserve station count
No setting
No setting
No setting
Reserve station count
No setting