Troubleshooting - Bissell PowerSteamer 1685 Series User Manual

Troubleshooting

Reduced spray or no spray.
Possible Causes
Bladder may be empty
1
The lint screen may be clogged
2
Tank-in-Tank may not be seated properly
3
Pump may have lost prime
4
The Pump Belt may be broken
5
Insert
Screwdriver
Blade Here
PowerSteamer is not picking up solution.
Possible Causes
Nozzle Window may not be
1
properly attached
Tank-in-Tank Lid is not
2
properly installed
Tank-in-Tank is not properly seated
3
Tank-in-Tank has picked up the maximum
4
amount of dirty water
Thank you for selecting a BISSELL product.
If you should happen to need assistance during assembly or operation, call: 1-800-237-7691
Please do not return this
product to the store.
WARNING:
To reduce the risk of fire,
electric shock, or injury,
unplug machine from
outlet before servicing.
Remedies
Turn power OFF, refill tank with hot tap water.
1
Turn power OFF, clean out lint screen,
2
follow step 2 on page 6.
Turn power OFF; remove and reseat tank.
3
Turn power OFF; after 1 minute, turn
4
ON and depress Spray trigger.
Turn power OFF and unplug machine
5
from outlet. To check if a Pump Belt
has broken, you will need a flathead
end into the lower slot of the Belt
Access Door to release the latch.
If necessary, insert the blade end into
the upper slot to release the upper
latch. Examine for belt breakage. You
should be able to see the Pump Belt
looped around the motor shaft. If it is
broken or missing, please refer to the
part numbers and descriptions on
page 11 before calling BISSELL
Lift Here
Consumer Services. Complete
installation instructions will accompany
the replacement belt.
Remedies
Make sure the two tabs on the back of
1
the Floor Nozzle Window are inserted
through the mating slots in the main
housing. Reinstall if necessary.
Reinstall lid; refer to page 6.
2
Tank-in-Tank must be firmly seated to
3
function. Remove and reseat Tank-in-Tank.
Empty tank and refill; refer to page 6.
4
screwdriver. Insert the blade
9