Cleaning; Cleaning The Chassis; Cleaning The Server Interior - Fujitsu PRIMERGY BX600 S3 Hardware Manual

Chapter 5 Maintenance

5.1 Cleaning

To prevent trouble from occurring, clean the server regularly.
This server should be cleaned as follows.
• Before cleaning, turn off the Chassis and unplug the power cables from the outlets. Also power
off peripherals and remove them from this product ( "3.3 Turning Off the Server" (p.24)).
Failure to do so may cause electric shock.
• Do not use any flammable aerosol cleaners. Doing so may damage the server as well as
cause fire.

5.1.1 Cleaning the Chassis

Wipe with a soft, dry cloth. For stains that do not come off with a dry cloth, wipe with a cloth lightly
dampened with a mild detergent. Once the stain has been removed, wipe off any remaining detergent
with a cloth dampened with water. When wiping the server, be sure that no moisture enters the Chassis.
Use a vacuum cleaner periodically to prevent dust buildup in ventilation holes.
In dusty environments, dust piles up on the front and rear panels of the Chassis over short periods.
Install the Chassis in a different location to avoid failures.

5.1.2 Cleaning the Server Interior

In dusty environments, dust deposits in the server. Dust deposits may cause a server failure, fire, or
electric shock. To keep the PRIMERGY server in good condition, use a vacuum cleaner periodically to
remove dust deposits.
Cleaning components
CPUs: Dust deposits must be removed because it will impair the cooling performance.
Fans: Remove dust from and around the fans.
Memory/expansion cards: Remove dust between memory modules and between expansion cards.
Remove dust from the connector before adding a memory module or an expansion card.
Internal hard disk units: Remove dust deposits from units and devices.
• Do not disassemble the PSU when cleaning the server interior.
Doing so may cause failures or electric shock.
62