Time-Of-Day Synchronization; Ethernet Addresses; Advanced Options; Msc Protocol Settings - Siemens SIMATIC S7-1200 CP 1243-8 IRC Operating Instructions Manual

Configuration
4.8 Ethernet interface
4.8.3

Time-of-day synchronization

Time-of-day synchronization
For the configuration of the time-of-day synchronization read the section Time-of-day
synchronization (Page 100).
4.8.4

Ethernet addresses

Ethernet addresses
In the following parameter groups you network the Ethernet interface and configure the IP
address parameters.
The networking of the serial interface is described in the following section: WAN parameters
(networking the CP) (Page 82)
You will find information on configuration in the STEP 7 information system.
Advanced options > Port [Xn P1]
You will find information on configuration in the STEP 7 information system.
4.8.5

Advanced options

4.8.5.1

MSC protocol settings

The parameter group is available only when using the ST7 protocol and when MSC
communication is enabled.
You configure the user name and password for the authentication with the MSC protocol in
the security functions.
MSC master station
The description applies to the parameter group of an Ethernet interface with the Network
node type "Master station". The parameter group is disabled for the CP.
Access to the MSC master station
First set whether the MSC master station or the router should be reachable with DNS via a
fixed or a dynamic IP address.
The MSC master station is connected to the Internet via a router.
72
Operating Instructions, 02/2018, C79000-G8976-C385-03
CP 1243-8 IRC