Ricoh Pro L5130 Rip Settings Manual page 24

2. Functions for L5130/L5160
Items
Pre-Heater
Print-Heater
Post-Heater
Cure-Heater
Auto Paper Cut
22
Selectable values
On/Off
20–70°C (68–158°F)
On/Off
20–70°C (68–158°F)
On/Off
20–95°C (68–203°F)
On/Off
20-95°C (68–203°F)
On/Off
60 mm (2.36 in)
80 mm (3.15 in)
100 mm (3.94 in)
Description
Specify the heater settings.
Specify these settings according to
the type and properties of the media
being used.
After decreasing the heater
temperature to secure sufficient
drying time, change the printer
settings as follows:
• Increase the value in "Drying
Time".
• Set "Printing Direction" to
"Unidirectional".
• Select a profile with a higher
resolution (more passes).
Depending on the operating
environment, increasing the heater
temperature may cause the
machine's interior temperature to
exceed the permitted range. Be
careful not to increase the heater
temperature too much.
If enabled, the paper is
automatically cut after printing.
Specify the margin when using the
Auto Paper Cut function.