Turn On The Tsw14J57Evm Power And Connect To The Pc; Turn On The Adc12Dj5200Rfevm Power Supplies And Connect To The Pc; Turn On The Signal Generator Rf Outputs; Open The Adc12Dj5200Rfevm Gui And Program The Adc And Clocks - Texas Instruments ADC12DJ5200RF User Manual

Turn On the TSW14J57EVM Power and Connect to the PC

3.6 Turn On the TSW14J57EVM Power and Connect to the PC
1. Turn on the power switch of the TSW14J57EVM.
2. Connect a mini-USB cable from the PC to the TSW14J57EVM.
3. If this is the first time connecting the TSW14J57EVM to the PC, follow the on-screen instructions to
automatically install the device drivers. See the
3.7

Turn On the ADC12DJ5200RFEVM Power Supplies and Connect to the PC

1. Turn on the 12-V power supply to power up the EVM.
2. Connect the EVM to the PC with the mini-USB cable.
3.8

Turn On the Signal Generator RF Outputs

Turn on the RF signal output of the signal generator connected to VIN. If external clocking is used, turn on
the RF signal outputs connected to DEVCLK and Reference clock.
3.9

Open the ADC12DJ5200RFEVM GUI and Program the ADC and Clocks

The Device Configuration GUI is installed separately from the HSDC Pro installation and is a stand-alone
GUI.
12
Setup Procedure
TSW14J57EVM user's guide
Figure 3-2. Configuration GUI EVM Tab
Copyright © 2019, Texas Instruments Incorporated
www.ti.com
for specific instructions.
SLAU640 – April 2019
Submit Documentation Feedback