Cisco Aironet 1520 Series Hardware Installation Manual page 45

Chapter 2 Mounting Instructions
Step 12 Position the two bolts on the access point into the access point quick-mount notch on the mounting
bracket (see
Note
Figure 2-15
Step 13 Screw a M8 x16 bolt (with flat and lock washers) into the second bolt hole on each side of the access
point (see
Step 14 Ensure the front of the access point is vertical, and tighten the four bolts to 13 to 15 ft lbs
(17.6 to 20.3 Nm).
Step 15 When using the optional Cisco external omnidirectional antennas, connect them to the access point as
shown in
Continue with the
Step 16
Point" section on page
OL-12632-02
Figure 2-15).
The access point should be positioned with the LEDs on the bottom to allow viewing from the
ground and with the hinged cover facing out.
Access Point Hanging in Mounting Bracket
Figure 2-15).
Figure 2-2. Hand-tighten the antennas to the access point.
"Grounding the Access Point" section on page 2-42
2-46.
Cisco Aironet 1520 Series Outdoor Mesh Access Point Hardware Installation Guide
Mounting the Access Point
and the "Powering the Access
2-29