Panasonic Panafax UF-885 Service Manual page 270

Panasonic UF-885 / 895
(12)
(14)
(15)
(20)
270
(13)
(16)
(18)
(18)
(12) Peel off the brown adhesive protector from the protective
film.
(13) Secure the protective film to the top of the Parallel Port
Interface Bracket as illustrated on the left.
(14) Connect the Ribbon Cables as illustrated on the left.
(15) Secure the Parallel Interface Assembly with the screw that
was enclosed with the kit.
(16) Connect the Ribbon Cables to the CN51 and CN52 on the
FCB PC Board.
(17) Re-install the Rear Cover.
(18) Re-connect the Power Cord and the Telephone Line Cable.
(19) Insert the Master Firmware Card that you have prepared
into the machine.
(20) Turn the Power Switch to the ON (I) position.
(21) Perform the Service Mode 9-1 (Firmware Update). (See
page 186)
(22) Perform the Service Mode 6 (Parameter Initialization). (See
page 179)
(23) Turn the Power Switch to the OFF (O) position.
(24) Remove the Master Firmware Card.
(25) Re-install the remaining Covers.
(26) Turn the Power Switch to the ON (I) position.