Sony HT-AF5 Operating Instructions Manual page 17

Tips
• The angle A should be the same.
A
30°
100°-120°
• Since the subwoofer does not emit highly
directional signals, you can place it wherever you
want. However, it is recommended to place the
subwoofer on the front edge of a table or rack, etc.,
to accept the remote signal correctly.
Installing the speakers on the
speaker stand
For greater flexibility in positioning the
speakers, you are recommended to use the
speaker stand as below.
Model Speaker stand
HT-AF5 Supplied. For details, refer to
the supplied Quick Setup
Guide.
HT-AS5 Optional WS-FV11 or
WS-FV10D speaker stand
(available only in certain
countries).
For details, refer to the
operating instructions supplied
with the speaker stand.
A
30°
100°-120°
Installing the speakers on the
wall
The front speakers of HT-AF5 is provided
with the speaker stand, you need to
disassemble the speakers.
Install the front speakers on the wall. Keep the
speaker stand for future use.
To disassemble the front
speakers of HT-AF5
(SS-TSB104)
1
Disconnect the speaker cords.
Rear of the speaker
2
Remove the screw
(pre-installed) at the rear of the
speaker.
This screw is used when reassembling the
speaker. Be sure not to lose the screw.
Screw
Rear of the speaker
continued
17 GB