Configuring E-Mail - Siemens SIMATIC HMI Series Operating Instructions Manual

Parameterizing the Mobile Panel
5.13 Configuring network operation
5.13.5

Configuring e-mail

You use this function to set the SMTP server, sender name and e-mail account for e-mail
service.
Requirement
● The Control Panel is open.
● Your system administrator has provided you with the necessary information.
Note
Additional tabs may appear in the "WinCC Internet Settings" dialog. This depends on the
options that have been enabled for operating the local network in the project.
Procedure
1. Open the "WinCC Internet Settings" dialog using the "WinCC Internet Settings" icon.
2. Change to the "Email" tab.
①
②
③
3. Specify the SMTP server.
– Select the "Use the default of ..." option if you want to use the SMTP server
– Clear the "Use the default of ..." option if you do not want to use the SMTP server
4. Enter the name of the sender in the "Name of sender" entry field.
The computer name is an appropriate sender name – see section
"Specifying the computer name of the HMI device (Page 131)".
5. Enter the e-mail account you use to send your e-mail in the "eMail address of sender"
entry field.
The "eMail address of sender" entry field can remain empty if your e-mail provider allows
e-mails to be sent without checking the e-mail account.
134
Setting of the SMTP server
Name of the sender and e-mail account
"Advanced" button for additional settings
configured in the project.
configured in the project. Enter the required SMTP server and the corresponding port.
Mobile Panels 2nd Generation
Operating Instructions, 09/2018, A5E33876626-AC