Basic Operation For Models With An Led Interface - Tripp Lite ECO350UPS Owner's Manual

Quick Installation
To disable ECO Energy Saving:
Double-click the UPS power button while the UPS is turned on and running from utility power.
The UPS confirms ECO mode is OFF via the LED or LCD interface:
• On single LED models, the green LED will be lighted continuously
• On 3 LED models, the green LED to the left of the PROTECTED LED will be lighted
continuously
• On LCD equipped models, the display will report ECO when the ECO status screen is off
Note: The "CONTROLLED BY MASTER OUTLET" receptacles available on the "SURGE ONLY" bank of
outlets provide surge and noise suppression only, they do not provide battery backup. During a power
failure, these outlets will be off regardless of whether the ECO energy-saving feature is enabled or
disabled. Select models include one battery-backup supported "CONTROLLED BY MASTER OUTLET"
receptacle.
Basic Operation
for Models with an LED Interface (ECO350UPS, ECO550UPS,
ECO650UPSM, ECO750UPS, ECO900UPSM)
UPS ON/OFF
• Plug the UPS into a live, grounded outlet: The SURGE ONLY outlets will begin passing
power.
• Plug equipment into the UPS: You will overload the UPS if the total volt-amp (VA) ratings
for all the equipment connected to the BATTERY BACKUP outlets exceed the UPS output
capacity. To find your equipment's VA ratings, look on their nameplates. If the equipment is
listed in amps (A), multiply the number of amps by 120 to determine VA. For example:
1A × 120 = 120VA.
• Turn the UPS on: Press and hold the power button next to the STATUS LEDs. The UPS
alarm will beep once briefly and the left-side green LED will illuminate. The BATTERY
BACKUP outlets will begin passing AC line power. The UPS will automatically recharge
internal batteries as needed. Once turned on, your UPS is ready to protect connected
equipment from blackouts, brownouts, overvoltages and transient surges.
• Turn the UPS off: Press and hold the power button next to the STATUS LEDs.
Note: UPS system will function properly upon initial startup; however, maximum runtime for the unit's
battery will only be accessible after it has been charged for 24 hours.
18-10-462-9338D5.indb 8
(All Models)
8
1/2/2019 4:16:48 PM