Tripp Lite ECO350UPS Owner's Manual page 11

Basic Operation
for Models with an LCD Panel (ECO850LCD, ECO900LCDU2)
UPS ON/OFF
• Plug the UPS into a live, grounded outlet.
The LCD panel will illuminate and the battery charger will engage as necessary. The SURGE
PROTECTED outlets will begin passing power.
• Plug equipment into the UPS: You will overload the UPS if the total volt-amp (VA) ratings
for all the equipment connected to the BATTERY/SURGE PROTECTED outlets exceed the
UPS output capacity. To find your equipment's VA ratings, look on their nameplates. If the
equipment is listed in amps (A), multiply the number of amps by 120 to determine VA. For
example: 1A × 120 = 120VA.
• Turn the UPS on: Press and hold the power button. The alarm will beep twice. The
BATTERY/SURGE PROTECTED outlets will begin passing AC line power. The UPS will
automatically recharge internal batteries as needed. Once turned on, your UPS is ready
to protect connected equipment from blackouts, brownouts, overvoltages and transient
surges.
• Turn the UPS off: Press and hold the power button until a beep is heard, then release.
Note: UPS system will function properly upon initial startup; however, maximum runtime for the unit's
battery will only be accessible after it has been charged for 24 hours.
18-10-462-9338D5.indb 11
11
1/2/2019 4:16:48 PM