BMW G 310 R Rider's Manual page 79

OA
without centre stand
Place the motorcycle on an
auxiliary stand. BMW Motorrad
recommends you use the
BMW Motorrad rear-wheel
stand.
Install the rear-wheel stand
( 66).
Lift the front of the motorcycle
until the front wheel is clear of
the ground, preferably using
a BMW Motorrad front-wheel
stand.
Installing the front-wheel stand
( 65).
Mask off the parts of the wheel
rim that could be scratched
when removing the brake cal-
iper.
Push apart the brake pads a
little.
Slacken clamping screws 1.
Remove screw 3.
Slacken clamping screws 2.
Press quick-release axle slightly
toward the inside, so as to be
better able to grip it on the
right-hand side.
Withdraw quick-release axle 4,
support the front wheel when
doing this.
Set down front wheel and
roll forwards out of the front
suspension. Ensure you do
not damage the wheel speed
sensor in the process.
8
77
z