Network No; Station No./Ip Address Settings - Mitsubishi Electric RD78G4 User Manual

Network No.

Set the network No. of the own station of the Motion module.
Item
Network No.
Precautions
Set a network No. that does not duplicate any other network Nos.
In particular, when using an Ethernet-equipped module (CPU module) at default, the IP address is 192.168.3.39 and the
network No. is the third octet of the IP address, thus 3. Because setting the network No. of the Motion module to 3 causes
duplication, set another network No.

Station No./IP Address Settings

Set the station No. of the own station of the Motion module.
Item
Station No.
IP Address
Subnet Mask
Default Gateway
2 PARAMETER SETTINGS
36
2.2 Required Settings
Description
Set the network No. of the Motion module.
Description
The station No. of the master station is fixed to 0.
Set the IP address.
Do not set the following values.
• The third and fourth octets are all 0 or all 1.
• The host address bits are all 0 or all 1
• Reserved address
Set the subnet mask.
Set the same value for the master station and slave station.
If the subnet mask is empty, the address class (class A, class B, class C) is determined from the
setting of "IP Address", and operation is done with the subnet mask according to the address
class.
The subnet mask for each class is as follows.
• Class A: 255.0.0.0
• Class B: 255.255.0.0
• Class C: 255.255.255.0
The IP address for each class is as follows.
• Class A: 0.x.x.x to 127.x.x.x
• Class B: 128.x.x.x to 191.x.x.x
• Class C: 192.x.x.x to 223.x.x.x
The host address for each class is the 0 section shown below.
• Class A: 255.0.0.0
• Class B: 255.255.0.0
• Class C: 255.255.255.0
Set the default gateway.
Setting range
1 to 239
(Default: 1)
Setting range

0.0.0.1 to 223.255.255.254
(Default: 192.168.3.253)
• Empty
• 0.0.0.1 to 255.255.255.255
(Default: empty)
• Empty
• 0.0.0.1 to 223.255.255.254
(Default: empty)