Compliance Statements For Nebs - Juniper ACX Series Quick Start Manual

ACX500 Universal Access Routers Quick Start—ACX500 Indoor Routers

Compliance Statements for NEBS

22
Mount the router at the bottom of the rack if it is the only unit in the rack.
When mounting the router in a partially filled rack, load the rack from the bottom to
the top with the heaviest component at the bottom of the rack.
If the rack is provided with stabilizing devices, install the stabilizers before mounting
or servicing the router in the rack.
When removing or installing an electrical component, always place it component-side
up on a flat antistatic surface or in an electrostatic bag.
When you install the router, always make the ground connection first and disconnect
it last.
Wire the DC power supply by using the appropriate lugs.
Do not work on the system or connect or disconnect cables during electrical storms.
Before working on equipment that is connected to power lines, remove jewelry, including
rings, necklaces, and watches. Metal objects heat up when connected to power and
ground and can cause serious burns or become welded to the terminals.
Failure to observe these safety warnings can result in serious physical injury.
AC power cable warning (Japan):
WARNING:
Translation from Japanese—The attached power cable is only for this
product. Do not use the cable for another product.
The recommended maximum ambient temperature is 158° F (70° C). For safe operation,
take into consideration the internal temperature within the rack.
Note the hot surface warning label on the top rear of the chassis.
The equipment is suitable for installation as part of the Common Bonding Network
(CBN).
The equipment is suitable for installation in locations where the National Electrical
Code (NEC) applies.
The battery return connection is to be treated as an isolated DC return (that is, DC-I),
as defined in GR-1089-CORE.