Grizzly T1188 Owner's Manual page 14

End-Trimming with
Router
Grizzly offers the T1189 Dual-End Trimmer
(see Figure 13) designed for cutting edge-
banding seams on straight or curved sur-
faces, as well as end-cuts.
Figure 13. T1189 Dual-End Cutter.
The T1188 also converts for end-trimming
operation by using the built-in edging tool
as a pivot point for vertical trimming.
To end-trim with router:
1. Apply edgebanding to workpiece and
route top edges of workpiece.
2. Pivot edging tool out from bottom of
base plate (see Figure 14), but do not
remove edging tool
Figure 14. Pivoting edging tool out of
base plate.
-12
-
3. Place edging tool on top of workpiece,
and align base plate with workpiece
edge, as shown in Figure 15.
4. Turn tool ON and slowly move bit into
edgebanding.
Move tool up and down along edge of
workpiece, keeping base plate aligned
and using edging tool as a pivot point,
as shown in Figure 15.
Figure 15. Aligning trim router to
workpiece corner.
Model T1188 Edgebanding Trim Router
Edging
Tool
Base Plate