Table of Contents
Advertisement
Adjusting Bit Depth
The trim router features a depth scale on
the motor body to be used with the depth
collar to fine-tune bit depth.
Note: The scale on the Model T1188 is not
calibrated to any specific point. Only use
it for reference when making incremental
changes.
Unplug tool and make sure switch
is OFF before inserting or remov-
ing bit, making adjustments, or per-
forming maintenance or service.
Never make adjustments while tool
is running.
To adjust bit depth:
1. DISCONNECT TOOL FROM POWER!
2. Loosen quick-release latch shown in
Figure 11, and turn base plate clock-
wise or counterclockwise to approxi-
mate desired depth of cut.
Quick-Release
Latch
Figure 11. Controls for bit-depth
adjustment.
Model T1188 Edgebanding Trim Router
Scale
Depth Collar
3. Fine-tune router bit depth using a pre-
cision measuring device, or place trim
router on workpiece and adjust bit
depth by eye.
Note: Depth collar provides increment
marks to help gauge adjustment depth
(see Figure 12). Each full rotation rais-
es/lowers the bit 2mm (
Figure 12. Increment marks on depth
collar.
4. Make sure power switch on trim router
is turned OFF, then connect router
to power and make a test cut on
a scrap piece of wood to verify bit
depth. Repeat Steps 1–4 until depth is
correct.
⁄
").
5
64
-11
-
Advertisement
Table of Contents
