Kurzweil MP120A User Manual page 8

Assembly Instructions
Chapter2
Assembling Left/Right Side Panel Stand
Side Panel(Left) Stand
Pedal Box Support
Side Panel(Right) Stand
Pedal Box Set Bolt
Assembling Back Panel
Back Panel
Back Panel
Set Bolt
Cable Clamps
Back Panel Set Screw
8 Assembly Instructions
Pedal Box
Pedal Cable
1) Put the cable in the Pedal Box ➍ out.
2) Starting with the left stand leg ➋ ,
place the Pedal Box ➍ on the Pedal Box
Supports , align the holes in the Pedal Box ➍
with the holes in the Stand Leg, then thread
the Pedal Box Set Bolts➐ into the holes.
3) Repeat with the right stand➌ and tighten all bolts
fully.
1) Place the Back Panel➎ on the assembled stand
legs. Align the holes in the Back Panel➎ with the
bracket in the stand legs, then fasten them by
using the Back Panel Set Bolts➑ as shown.
2) Attach the Pedal Box➍ to the bottom of the Back
Panel➎ and thread the Back Panel Set Screws➒
into the 4 holes.
3) After placing the Cable Clamps➓ over the pedal
cable, stick it on the back panel, then arrange
the cable behind the Back Panel➎.
Caution
Please arrange the pedal cable after completely
assembling the back panel with the side panel
and pedal box.