Menu Options; Walk Test - Honeywell Accenta Series Engineer's Manual

Menu Options

Menu Options
The full menu structure for the panel can only be accessed while in Engineer program mode. The structure is
shown in the following table:
Enter Engineer program mode. Press [PROG] [9] [9] [9] [9].

0 = Walk Test

The walk test function allows each detector to be checked in order to verify that they are functioning correctly.
A tone is generated as each zone is activated (opened).
LCD keypad
• Press [up arrow] for menu Walk Test.
• Press [SET] or [0]. Zones 1-8 have a zero (0)
below each number.
• When a zone is sucsessfully tested, number 1
replaces the 0. Zones are added to list as each
one is activated.
• Press [RESET] to leave the menu or [SET] to
restart the Walk Test.
LED keypad
• Press [0] for menu Walk Test.
• Press [SET]. Zones 1-8 are off
• When a zone is sucsessfully tested, the LED is on.
Zones are added to list as each one is activated.
• The Tamper LED comes on when tested.
• Press [RESET] to leave the menu or [SET] to restart
the Walk Test.
MENU OPTIONS
0 = Walk Test
1 = Alarm Test
2 = Test Outputs
3 = System Flags
4 = Time and Date
6 = Zone Names
Table 2. Menu Options
Accenta/Optima Engineer's Manual
7 = Timers
8 = Codes
C = View Event Log
O = Omit Allow & Double Knock
P = Set up Programs
0>Walk Test 0>Walk Test
0>Walk Test 0>Walk Test 0>Walk Test
0>Walk Test 0>Walk Test 0>Walk Test 0>Walk Test 0>Walk Test
18
[up arrow]
[SET] or [0]
12345678 12345678 12345678 12345678 12345678 TP TP TP TP TP
00000000 00000000 00000000 00 00 00
00000000 00000000 00 00
[RESET]
[SET]
1 2 3 4 5 6
[RESET]
1 2 3 4 5 6
7 8
7 8