Sony PDW-F30 Operating Instructions Manual page 98

Alarm message in time
data display section
b)
SB CLP mode
b)
SUB CLIP NG
b)
No List!
b)
STOP ONCE!
No EM space
EM Full!
Disc Damage
NON-AV Full
Index File!
File System
a)
Loading!
a)
Unloading!
a) Displayed only when DISPLAY CONTROL >ALARM is set to "ON".
During recording and editing operations
Alarm message in time
data display section
a)
HD 60I/30P
a)
HD 50I/25P
a)
HD 23P Disc
98
Troubleshooting
Alarm message in monitor video
section
TO ADD AN ESSENCE MARK, EXIT
FROM SUB CLIP MODE FIRST.
SUB CLIP IS INVALID.
SET APPROPRIATE IN/OUT POINTS.
NO CLIP LIST.
STOP ONCE, THEN EXECUTE.
ESSENCE MARK NOT RECORDED.
NO SPACE AVAILABLE TO RECORD
ESSENCE MARK.
NO MORE ESSENCE MARKS CAN BE
RECORDED.
DISC CANNOT BE RECORDED TO.
USE ANOTHER DISC FOR RECORDING.
DISC CANNOT BE RECORDED TO.
FOR MORE RECORDING SPACE,
DELETE CLIPS OR NON-AV DATA.
(GENERAL FILES)
UNSUPPORT INDEX FILE.
DISC CANNOT BE RECORDED TO.
CURRENT VERSION OF THE
SOFTWARE SETS THE DISC WRITE
PROTECTED.
FILE SYSTEM ON THE DISC INHIBITS
WRITING.
LOADING.
UNLOADING.
Alarm message in monitor video
section
DISC CANNOT BE RECORDED. HD 60I
or HD 30P CLIP(S) EXIST.
DISC CANNOT BE RECORDED. HD 50I
or HD 25P CLIP(S) EXIST.
DISC CANNOT BE RECORDED. HD
23.98P CLIP(S) EXIST.
Description/action
This appears when you press the ESSENCE MARK
(SHIFT + THUMBNAIL) button with the SUB CLIP
button lit.
Try again after pressing the SUB CLIP button to turn it
off.
Set the In and Out points again.
This appears when you try to delete a clip list when
there is no clip list saved on the disc.
Load the disc that contains the clip list you want to
delete.
This appears when you press the SUB CLIP button
during clip list playback.
Stop the playback and try again.
Use the PDZ-1 Proxy Browsing Software to delete
unneeded essence marks.
Use another disc.
Delete unneeded clips or GENERAL files.
Use another disc.
This appears when you insert a disc that can be
played back but not recorded.
Exchange the disc for one with a file system
supported by this unit. Or format the disc (see page
36).
This appears if you press a button while a disc is
loading. Wait until the disc has finished loading and
try again.
This appears if you press a button while a disc is
unloading.
Wait until the disc has finished unloading and try
again.
b) Displayed only when DISPLAY CONTROL >ALARM is set to "ON" or
"LIMITED".
Description/action
This appears when the system frequency of this unit
does not match that of the loaded disc.
Insert a disc that matches the system frequency, or
change this unit's system frequency setting (see page
22).