Settings For Editing; Recorder Settings - Sony DSR-70 Operating Instructions Manual

Settings for Editing

Settings for Editing

Recorder Settings

38
Chapter 3 Editing
When using two units of the DSR-70/70P as a pair of recorder and player
in an editing system, set the recorder and player as follows. Basically, the
same recorder settings and player settings apply when you use a DSR 70/
70P unit as a stand-alone recorder or player.
Make settings as follows.
POWER indicator
Sub LCD
1 4
TC
LOCAL INT
REMOTE EXT
7
2
1
Set the REMOTE/LOCAL switch to LOCAL.
2
Set the POWER switch to ON, then make the following checks.
When the unit is powered, the POWER indicator lights and the sub
LCD home page appears in the sub LCD.
Check Indication/What to do
Enough Check the remaining battery power indication.
battery
power If "BATT" is flashing
remaining? Replace the battery.
No If "HUMID!" is displayed
condensation Leaving the unit powered, wait until the message
in the unit? disappears.
(In this case, the alarm message "MOISTURE
HAS BEEN DETECTED" also appears on the
LCD monitor.)
6
5
3
UP/DOWN buttons
See for details
" 5 Remaining
battery power
indication" (page
67)
"Condensation"
(page 127)