Sony DSR-70 Operating Instructions Manual page 109

Item number Item name
605 TCG REGEN
MODE
607 U-BIT BINARY
GROUP FLAG
610 REGEN
CONTROL MODE
611 TC OUTPUT
PHASE IN EE
MODE
612 TC OUTPUT
MUTE IN
SEARCH MODE
Menu items in the 600s, relating to the time code generator
Settings
Select the signal to be regenerated when the time code generator is in the regeneration
mode (i.e., when the PRESET/REGEN item in the sub LCD menu general settings page
is set to REGEN, or the unit is in automatic edit mode).
TC&UB: Both the timecode and user bits are regenerated.
TC: Only the timecode is regenerated.
UB: Only the user bits are regenerated.
Select the user bits to be used in the time code generated by the time code generator.
000: Character set not specified.
001: 8-bit characters compliant with ISO 646 and ISO 2022.
010: Undefined.
011: Undefined.
100: Undefined.
101: SMPTE 262M page/line multiplex system.
110: Undefined.
111: Undefined.
When editing with two DSR-70/70P units, if you use the control panel for editing
operation, select whether or not the timecode is automatically regenerated.
AS&IN: In editing with this unit as the recorder, regardless of the settings of the TC INT/
EXT switch and sub LCD menu item PRESET/REGEN, in assemble and insert editing ,
the timecode generator regenerates according to the timecode on the tape.
ASSEM: In editing with this unit as the recorder, regardless of the settings of the TC
INT/EXT switch and sub LCD menu item PRESET/REGEN, in assemble editing only,
the timecode generator regenerates according to the timecode on the tape.
MANU: Regardless of whether this unit is the recorder or player, the timecode
generator operates in accordance with the settings of the TC INT/EXT switch and sub
LCD menu item PRESET/REGEN.
FULL: Regardless of the REMOTE/LOCAL switch setting, when any of the ASSEMBLE,
VIDEO, AUDIO CH1,1/2, AUDIO CH2,3/4, and TC buttons is lit, the timecode generator
regenerates according to the timecode played back from the tape.
Select the timecode output mode for output from the TC OUT connector in E-E mode.
MUTE: Mute the output.
THRU: Output the timecode input to the TC IN connector as it is.
V-IN: Output the timecode with the same phase as the input video signal phase.
V-OUT: Output the timecode with the same phase as the output video signal phase.
Select whether to mute the output from the TC OUT connector in search (jog/shuttle)
mode.
ON: Mute.
OFF: Do not mute.
109
Chapter 7 Setup Menu