Playing Back Scenes Extracted From Clips (Program Playback) - Sony DSR-DR1000A Operating Instructions Manual

Playing Back Scenes
Extracted From Clips
(Program Playback)
Scene A
Clip 1
Sequence of the scenes being played back
The following example explains how to extract scenes A to
D and play them back in the order B, D, C, A.
1
In clip 2, cue up the point that you want to use as the
In point of scene B.
2
With the SET button held down, press the K (IN)
button.
"IN set" appears in the time counter, and the LED to
the side of the K (IN) button lights. The In point
timecode appears in the operation mode display area
below the time code display on the monitor screen.
3
Cue up the point that you want to use as the Out point
of scene B.
4
With the SET button held down, press the k (OUT)
button.
"OUT set" vappears in the time counter, and the LED
to the side of the k (OUT) button lights. The Out
point timecode appears in the operation mode display
area below the time code display on the monitor
screen.
5
With the CLIP button held down, press the SET
button.
"CLIP set" appears in the time counter and scene B is
registered.
When the In/Out points are registered, the In and Out
points timecodes disappears and the operation mode
is displayed below the time code display on the
monitor screen.
Note
An exclamation point (!) appears after "CLIP set" and
the message "SUB CLIP IS INVALID" appears on
44

Playing Back Scenes Extracted From Clips (Program Playback)

Scene Scene
Scene B
C D
Clip 2 Clip 3
the monitor screen if there is a problem in the segment
definition, for example when the Out point is defined
in advance of the In point. Reset the Out point.
6
Proceed in the same way to define scenes D, C, and A.
7
With the CLIP button held down, press the PLAY
button.
The scenes are played in the order B, D, C, A.
Numbers are assigned to extracted scenes in the order
that you create the segments and displayed in
playlists.