Saving Or Deleting Received Data - Sony DSR-DR1000A Operating Instructions Manual

3
Select CLIP in the RECEIVE CLIP screen, and press
the k (OUT) button.
The CLIP SELECT screen appears.
CLIP SELECT
< 01: AAAAAAAA
CLIP:
SHIFT : (< -)(- >)KEY
CHAR SELECT :
DELETE : RESET KEY
DATA SET :
TO MENU :
4
Refer to step 1 of "Registering Host information in an
Address Book" (page 50) and enter the name of the
clip you want to receive (up to 11 characters), and
then press the SET button.
You return to the RECEIVE CLIP screen.
5
Press the SET button.
Preparations for communications start.
When the preparations finish, the message "Issuing
transfer request. Will begin transfer after the end of
transfer standby." appears.
Up to 29 transfer requests can be placed on standby.
When the 30th request is issued, the message
"Request queue full. Cannot send clip." appears and
the transfer is rejected.
To cancel the transfer
In step 5, press the MENU button instead of the SET
button.
>
JOG DIAL
SET KEY
MENU KEY
Saving or Deleting
Received Data
The NEW CONTENTS indicator on the front panel of this
unit light when new data is received. Use the following
procedure to check the data and to save or delete it.
1
Select the NEW CONTENTS LIST item in the
Network menu and press the k (OUT) button.
NETWORK MENU
SEND
RECEIVE
ADDRESS BOOK
NEW CONTENTS LIST LIST
STATUS
Monitor screen
A list of received data that has not yet been save appears.
The list indicates the type of data (clip or address book)
and the time when it was received.
NETWORK MENU
NEW CONTENTS LIST
CLP 01 31 12:15
CLP 10 05 12:30
CLP 08 02 17:31
ADR 08 19 23:59
??? 07 01 00:01
If there is no new received data, the message NO
NEW CONTENTS appears.
2
Select the data you want to check and press the k
(OUT) button.
The NEW CONTENTS INFO screen appears..
New Content
Time counter display
Clip data
Address book data
Data type unknown

Saving or Deleting Received Data

55